To connect Kerio Connect to Microsoft Active Directory: On the Microsoft Active Directory server, install the Kerio Active Directory Extension. In the Kerio Connect administration interface, go to Configuration > Domains. Double-click the domain and switch to the Directory Service tab. Select Map user accounts and groups from a directory service. In the Administration interface, go to Configuration -> Interfaces. Double-click on VPN Server. In the VPN Server Properties dialog, check Enable Kerio VPN Server. Select the Kerio VPN tab and select a valid certificate. Port 4090 is set as default. Both TCP and UDP protocols are used. To specify a VPN route manually, refer to Configuring VPN DNS name of the server with Kerio Operator. Supported browser. (Go the End-user tab in the link to see the supported browsers.) To log in, enter the DNS name of the computer with Kerio Operator: kerio.operator.name/admin; Administration runs solely via the HTTPS protocol on port 4021. The address is automatically redirected to: One is running on Webadmin Https Port 31001 ( 9.3 )( Web Interface for Admin ) Question 1 )The new one is on Port 4081 ( Standart ) - i dont find the option to change it ? Question 2 ) VPS Server only Kerio - is there a way for Administration without Webadmin Https interface ? In this example, a USB SIM-card dongle is being plugged into a USB 3.0 port. Internet port is a primary Internet link, connected initially. LAN1 port is used for direct PC connection. LAN2 port remains free. Once the USB dongle is plugged, it appears in the Other Interfaces group in Kerio Control Webadmin Interfaces. Kerio Connect uses HTTP and HTTPS over port 4040 for the WebAdmin and this can be accessed from any of the supported browsers: http://www.kerio.com/connect/requirements. Verify if the startup type is set to Automatic. Log into Kerio Connect Administration. Go to Configuration > Services and make sure the Startup Type is set to Automatic. If the Startup Type is not set to Automatic, select each service in the table and set the type to Automatic. Upon restating Kerio Connect, the service should auto-start. Kerio Control Hangs and Requires Restart. Prevent Clickjacking on Kerio Control Web Interface. Allow Website but Block Videos on the Site. External IP Address Interface for Dynamic DNS. Unknown Traffic to DNS Servers in Kerio Control Environment. Setting minimum bandwidth for IP address. Setting daily quota bandwidth restrictions. In Kerio Control's administration interface, navigate to Configuration > Traffic Rules. Click Add. The Add New Rule window opens. In the Add New Rule window, type a name for the rule (in the example rule above, 'Web1 server mapping') and click Next. In the Source tab, leave it as Any sources and click Next. Save the kerio-control-factory-reset file to the flash drive. Switch off Kerio Control. Plug the USB flash drive into one of the USB ports of your Kerio Control. Switch on Kerio Control. Once Kerio Control boots, the box beeps once. Once the configuration is reset, the box beeps once. AeYOKqW.